23 Jan Key Differences Between Thermal and Cold Spray – Essentials to Remember
Comparison between thermal spray and cold spray insulation has been made in a variety of circumstances. It is necessary for those homeowners who are seeking to obtain the highest level of protection within their residence or businesses.
It is also necessary for those commercial building managers who are looking at obtaining the lowest cost-effective level of insulation. This type of comparison is critical because it allows for a company or individual who is seeking the right level of protection to make the proper selection.
If an individual chooses incorrectly, they could be wasting money or insulation that will not do the job that they are looking for. The first step in the comparison between thermal spray insulation and cold spray insulation is to determine the amount of insulation needed.
The interior walls, attic insulation, and basement walls are typically the areas that will need to be addressed. For those that have already implemented the spray application, the area that is between the ceilings and walls may be considered.
For those that have not installed the spray application, then the outside walls and roofs may be the areas to focus on. Next, the area that needs to be insulated must be measured. Each wall and ceiling should be carefully measured so that the best possible fit can be achieved.
A good rule of thumb is to ensure that the inside perimeter of the sprayed area is four times the thickness of the sprayed foam insulation. Once this has been determined, the insulation material can be chosen. When choosing the insulation material, it is important to ensure that the material is the correct type.
There are two main types that can be used. These types are cellulose and spray foam. Spray foam insulation has a tighter weave than traditional cellulose. It is also more durable than the traditional form. The other form of insulation is commonly referred to as drywall or gypsum board.
Cold Spray insulation is usually applied directly to the wall while spray foam insulation can be applied using a brush or roller. A disadvantage of spray insulation is that it does not provide as much flexibility as drywall. It is also very fragile and can easily be damaged.
Once the wall and ceiling have been constructed and tested to ensure that they are suitable for insulation, the next step in the comparison between thermal spray and cold spray is to ensure that sufficient amounts of each type are supplied for the application being made.
Depending on the application, the amount of spray needed will vary. If an individual is insulating an attic, then a greater amount of spray would be required. This would ensure that adequate insulation is achieved in the attic. If wall insulation is being installed in a basement, then less spray would be required.
When comparing thermal spray and cold spray insulation, it is important to remember that both types of insulation are available in rolls.
The difference between the two is that cold spray insulation is applied with a compressor and can be used on masonry walls and ceilings to the hot-air version are applied with a gun and are more suitable for attic insulation.
Cold spray foam insulation, when using the hot-air method, must be applied to walls and ceilings and should ensure that the wall has been prepared to accept the insulation before it is used. Another way to compare thermal spray and cold spray foam insulation is to request quotes from contractors who specialize in either one or both techniques.
Contractors will often have previous experience with either type of insulation and will therefore be able to offer advice based on their experiences. Alternatively, you could request a quote from an insulation contractor. In this case, it is likely that they will know which type of insulation is most suitable for your needs.